3. There is also a kind of adhesive hook and loop for 3M adhesive products, that is, using 3M adhesive to cut into the corresponding specifications and attaching the back of the hook and loop product, which is a relatively special high-grade processed product.Ordinary adhesive processing can process adhesives from specifications between 12.5-200mm wide. Ordinary adhesive processing can process the following materials; ordinary hook and loop adhesive, plastic hook backing, velour backing and other back-to-back processing materials can be : Ordinary hook and velour processing, plastic hooking and velour processing, ordinary hooking ordinary loop processing.After buying it, how do we check the size of the hook and loop and the adhesiveness of the adhesive? The following LiYao gives you a brief introduction to the sticky test of the adhesive hook and loop, I hope to help everyone.The size can be measured by the ruler. If the adhesive is sticky, you can cut a small piece and paste it repeatedly to test its stickiness. When it is torn, the sticky one will be difficult to tear off. Good glue will obviously see one. A thick layer of transparent glue, and vice versa.However, if it is stuck on the object to be used, be careful not to touch the adhesive when you peel the adhesive, because the grease on the hand will affect the adhesiveness of the adhesive.
The adhesive hook and loop machine can process ordinary adhesive processing or back-to-back bonding.